Numerical Analysis of Tooth Wear with Engineering Software
Tooth wear is a common mechanical problem on excavators, loaders, graders, and other machines that constantly contact abrasive soil and rock. Wear raises maintenance cost and cuts productivity. Numerical wear analysis lets engineers simulate material loss under realistic loads without expensive full-scale trial programs. Using finite-element and multiphysics software, teams can refine tooth geometry and alloy choice before production. Taimaz Foolad (Metco) applies wear-focused metallurgy when developing cast bucket teeth and GET.
Simulation Software Used for Tooth Wear
- ABAQUS: advanced contact models (general contact, surface-to-surface) for friction and progressive wear
- ANSYS Workbench: coupled stress–thermal–wear studies where frictional heat matters
- LS-DYNA: impact and highly dynamic digging events
- COMSOL Multiphysics: custom wear equations for research and tailored models
Mathematical Wear Models
Archard’s law remains the most widely implemented relation:
V = K · (F · L) / H, where V is wear volume, K the wear coefficient, F normal force, L sliding distance, and H hardness.
Other approaches include Rabinowicz particle-formation concepts, energy-based wear models, temperature-dependent wear (tooth tips can approach several hundred degrees Celsius), and multi-stage models covering run-in, steady state, and accelerated wear.
Required Inputs
- Geometry: length, width, rake/attack angle, tip radius
- Material: alloy class (for example Hardox or NM400 families), hardness, elastic modulus, Poisson’s ratio, experimental K
- Loading: normal force, sliding speed, contact angle, soil/rock particle size and hardness
- Environment: temperature, moisture, presence of lubricant or slurry
Useful Outputs
Simulations predict service life via wear volume, mass loss, thickness reduction, and load-cycle count. Stress maps show hot spots that guide geometry changes, hardfacing placement, or alloy upgrades before tools enter abrasive ground.
Numerical wear analysis shortens development loops for GET. For field-proven cast excavator and loader teeth backed by practical metallurgy, contact Taimaz Foolad (Metco).







